MITSUBISHI ELECTRIC WS-48513 - Manual (Page 90)

90 91
If the remote control has not been
programmed to operate NetCommand and
slide switch is set to TV when you enter an
A/V receiver code, VOLUME and MUTE will
control the A/V receiver rather than the TV.
To return volume and mute control to the TV,
set the slide switch to TV, press and hold
POWER and enter 000.
IMPORTANT
IMPORTANT
Some manufacturers may change their
products, or they may use more than one
remote control system. If this is the case,
your remote control may not be able to
operate your VCR, DVD, cable box, satellite
receiver, or A/V receiver.
After entering the correct codes in each position of the remote control, use the slide switch to select which product will
respond when an operational button is pressed. If the TV position has not been programmed to control NetCommand
and you enter a code from the A/V Receiver chart while the slide switch is set to TV, the volume and mute functions
change to match the A/V receiver. This is useful when using an A/V Receiver with the TV all the time. In all other cases,
only one of the below devices is allowed for each slide switch position.
TV position (when the remote has not been programmed to operate NetCommand):
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR DVD LD Player
DVD position:
DVD LD Player
Cable box VCR
Audio position:
A/V receiver Cable box
Mitsubishi CD player
[If you have a Mitsubishi A/V receiver, the audio position may be used in conjunction with selected Mitsubishi
CD players. Your audio position must be programmed to 010 ].
Appendix C: Remote Control Programming Codes