MITSUBISHI ELECTRIC WS-48513 - Manual (Page 64)

64 65
To view a V-Chip blocked program or to watch the
program during a scheduled lock time, you must enter
your 4-digit passcode or change the channel to an
unlocked program. Once you have entered the passcode,
the V-Chip block or Lock by Time will remain released
until the TV is powered Off and then On again.
V-Chip Lock Menu: Passcode
V-Chip
Select V-Chip Lock to perform the functions listed below.
V-Chip allows you to Block or Allow programs based upon
rating signals sent by the broadcaster. The TV comes
from the factory with the V-Chip Lock in the Off setting.
You can turn the V-Chip on within the V-Chip Menu or
you can use the V-CHIP button on the remote control to
conveniently turn the V-CHIP on or off.
The factory preset is TV-PG for TV ratings or PG for movie
ratings, allowing only programs rated TV-PG/PG or lower.
You can change the blocking level to various TV ratings
and lettered categories or movie ratings. After changing
channels or devices, there may be up to a 5 second delay
before the V-Chip lock takes effect.
Entry
Figures 16 and 17
You will see the screen shown in Figure 16 when you press
V-CHIP on the remote control, or the first time you select
the V-Chip Lock menu, or after you have canceled your
passcode. To use the Lock, input a four-digit passcode
with the number buttons on the remote control, then
press ENT(er). You can delete a number and move back
one space by pressing CANCEL. You can exit without
inputting a passcode by pressing MENU or HOME.
After setting a passcode, the V-Chip Lock is active. The
next time you select V-Chip Lock you will see “...enter
your passcode” instead of “...enter a new passcode”.
������ ������ ����
�� �� �� ��� ����� ����� � ��� ���������
� � � �
��� ��� ������ ������� ��� ����� ������
V-Chip Start Time and V-Chip Stop
Time
Figure 18
Select the times you would like the V-Chip to be active.
By setting the V-Chip Start Time and V-Chip Stop Time to
the same time, the V-Chip will be active 24 hours a day.
Press ADJUST or to slowly select the time, starting
with the hours. Press and hold ADJUST or to
quickly select the hours, press ADJUST to select the
minutes.
If you forget your four-digit Passcode, see
Appendix A.
IMPORTANT
������� �� �������
������ ������ ��� ������� ������� ��� ������ ��
����� ����
�� ����� ��� �������� ����� ���� ���������
� � � �
��� ��� ������ ������� ��� ����� ������
Figure 16. V-Chip Entry screen
Figure 17. V-Chip Passcode screen
Figure 18. V-Chip Menu, Start & Stop Time