MITSUBISHI ELECTRIC WS-48513 - Manual (Page 43)

42 43
Edit NetCommand ® , Adding Devices, continued
Input-DTV Connection Screen
Figure 23
This screen displays only if the device selected in the
Connection screen (Figure 19) is connected to Input-DTV.
This is usually DBS, but can be Cable Box. The Input-DTV
Connection screen allows you to select the connection
type, RGB (HV) or Component YPbPr you are using to
connect your cable box or DBS.
Fixed Channel Screen
Figure 22
If the device being connected is a cable box and the “RF”
box is checked (Figure 21), the Fixed Channel screen
allows you to select the channel number used for output
by your cable box. The Fixed Channel screen allows you
to select the channel number that is used for output by
your cable box. The default channel is 003.
Figure 22. F ixed Channel screen
Figure 23. Input-DTV Connection screen
Please refer to the Editing Guide on page 34 to see if the screen described below is necessary for your device setup.
IR Code for [Device] Screen
Figure 24
This screen only displays if an added device has the same
IR code as a previously added device of the same type
and manufacturer. You can specify the IR setting for
the new device. For example, for the second Mitsubishi
VCR you can specify the IR Code setting to VCR-B, if the
primary Mitsubishi VCR is using the VCR-A IR code.
Figure 24. IR Code for [Device] screen
RF Connection for Cable Screen
Figure 21
The RF Connection screen displays only when Adding or
Changing a Cable Box. If your Cable Box is connected
to a TV Antenna input, make sure the RF checkbox is
checked. Select the TV antenna input that is used with
the Cable Box. If the Cable Box is also connected to a
VCR for recording, select that VCR.
If your Cable box is connected using Audio/Video cables,
make sure the RF checkbox is unchecked. Then the
next screen will be Connection (Figure 19), to allow the
selection of the TV input used with the Cable Box.
Figure 21. RF Connection for Cable screen