MITSUBISHI ELECTRIC WS-48513 - Manual (Page 30)

30 31
Figure 3. Programming the TV remote to control your
NetCommand A/V devices.
NetCommand CODE to ENTER
TV Control and NetCommand Devices:
935
NetCommand R
POWER 1. 2.
3.
TV AUDIO
CABLE/DBS/DTV DVD VCR
Code
Programming the Remote Control to Control NetCommand
A/V Products
To Program the Remote to Control NetCommand A/V Products
Figure 3
(See NetCommand Supported Devices, for the list of A/V products supported by the NetCommand System.)
1. Move the slide switch at the top of the remote to the TV position.
2. Press and hold the POWER button on the remote control.
3. Enter the three digit code of 935, and then release the POWER button on the remote control.
4. The remote control is now programmed to send NetCommand signals to the TV so the TV can control the IEEE 1394
devices and older NetCommand supported or learned IR devices, while the slide switch is in the TV position.
Note: To return the remote to the original configuration, repeat Steps 1 and 2. At Step 3, enter the code 000 and
release the POWER button on the remote control.
The NetCommand Learning feature is able to learn the remote control signals of most Audio Video devices. However,
there will be some signal sets that NetCommand cannot learn or you may choose to not use NetCommand. For
these conditions you will find that the remote control has many brands of products already in the TV’s remote control
memory. See Appendix C for instructions on programming the remote control to operate these products independently
of NetCommand. These additional remote control features are enabled by moving the slide switch at the top of the
remote to other device positions.