20 21 connecting an analog vcr, Vcr to analog antennas or wall outlet cable, Vcr to a cable box – MITSUBISHI ELECTRIC WS-48513 User Manual
Page 20: Figure 5, Figure 6
20
21
Connecting an Analog VCR
VCR to Analog Antennas or Wall Outlet
Cable
Figure 5
1. Connect the incoming cable to ANT-A on the TV back
panel.
Connect two coaxial cables as follows
2. One from LOOP-OUT on the TV back panel to
ANTENNA IN on the VCR back panel.
3. One from VCR back panel ANTENNA OUT to ANT-B on
the TV back panel.
4. Now complete Connecting Composite Video or S-Video
and Audio Connections, step 1 and 2 on the following
page.
VCR to a Cable Box
Figure 6
1. Connect the incoming cable to ANT-A on the TV back
panel.
Note: Connect three coaxial cables as follows:
2. One from LOOP-OUT on the TV back panel to IN on the
back of the cable box.
3. One from OUT on the back of the cable box to
ANTENNA IN on the VCR back panel.
4. One from ANTENNA OUT on the VCR back panel to
ANT-B on the TV back panel.
5. Now complete Connecting Composite Video or S-
Video and Audio Connections, step 1 and 2 on the
following page.
IR EMITTER
NetCommand
REPEATER
ANT-A
LOOP-OUT
ANT-B
RIGHT
LEFT
VGA VIDEO
640 x 480 60Hz
M-LINK/
DVI
VGA
AUDIO
M-LINK
CONTROL/
RS-232C
V
H
��
���
�������
� � � ���� �����
�
�
�������� � ����
�
����� ���
����� ��
� ��� � ���
�� �� �
����� ��
�
�
�
�
�
�
�
�
�
����� ���
����� ��
����� ���
�����
�������
�
�
�
�
�
�
�
��
���
�������
��� ���� �����
�������� �����
����� ���
���� ���������
��
���
�
�
�
�
�
�
�
�� ���� ����� �������� �������
Note: NetCommand® assumes your VCR will
be connected to inputs as shown on the next
page. If you use any other inputs for your VCR or
add a second VCR this change must match in the
NetCommand system. See “Editing NetCommand
Setup” in Chapter 3 for more information.
Figure 5. Connecting a VCR to Analog Antennas or Wall
Outlet Cable
Figure 6. Connecting a VCR to a Cable Box