Marantz BD8002 - Manual (Page 16)

13
Connections Connections
ENGLISH
ENGLISH
Analog 7.1ch/5.1ch audio signals can be output from 7.1ch AUDIO OUT jacks.
After you made all necessary connections, connect the AC cord to the AC IN. Then connect the AC
cord to the AC outlet.
Connection to a Device with 2-channels of Analog Audio Inputs
Supplied cables used in this connection are as follows:
• RCA audio cable (L/R) x 1
Note
• When connecting to a 2-channel audio stereo device, use the 2ch AUDIO OUT jacks. If the 7.1ch
AUDIO OUT jacks are used, set “7.1ch Audio Out” in the “Audio” menu to “2 Channel” (Refer to
page 33). For software recorded in multi-channel, analog signals that have been down-mixed
into 2 channels are output. (For sources which are prohibited from down-mixing, only the FL/FR
signals are output.)
Surround Connections to a Device with 7.1/5.1-channels of Analog Audio Inputs
Supplied cables used in this connection are as follows:
• RCA audio cable (L/R) x 1
Please purchase the rest of the necessary cables at your local store.
R
L
AUDIO IN
audio
this unit
RCA audio cable
Stereo component
R
SURROUND
L
CENTER
SUB-
WOOFER
R
SURROUND
BACK
L
R
L
FRONT
AV amplifier
audio
this unit
Note
• If you connect to 5.1-channel surround system, do not connect to SBR/SBL (surround back R/L)
jacks, then set “Surround Back” in “Speaker Configuration” to “None”.
Connecting the AC cord
Supplied cables used in this connection are as follows:
• AC cord x 1
Note
• Insert the plugs securely. Incomplete connections will result in the generation of noise.
AC outlet
AC cord
AC 120V, 60 Hz
E5E30UD_EN.book Page 13 Thursday, May 22, 2008 3:43 PM