Marantz BD8002 - Manual (Page 40)

37
Function Setup Function Setup
ENGLISH
ENGLISH
Ⅵ Others
• For how to select the setting items and options, refer to “Custom” on page 29.
Initialize the setting or SD Memory Card.
1) Press [SETUP] in stop mode.
2) Use [Y / Z] to select “Initialize”, then press [ENTER].
3) Use [U / V] to select a desired option, then press [ENTER].
“No” :Exit without any initialization.
“Setup” :Reset the SETUP setting to the factory default.
“Memory Device” :Initializes the SD Memory Card. After confirmation message appears, use
[U / V] to select “Yes”, then press [ENTER].
4) Press [ENTER]. (For “Setup” and “Memory Device” only)
5) Press [SETUP] to exit.
Setting items Options
Angle Icon On:
The angle icon appears on the screen when playback
the scene with various angle.
Off*:
The angle icon disappears on the screen.
Screen Saver On*:
If this unit is left with no activity for more than 5
minutes, the screen saver will be activated.
Off:
Sets off the screen saver.
Auto Power Off On*:
If this unit is left with no activity for more than 30
minutes, this unit turns off automatically.
Off:
Sets off the auto power off.
Panel Display
Sets the brightness of the front
panel display. Bright*:
Front panel display gets brighter.
Dimmer:
Front panel display gets darker.
Auto:
Front panel gets darker during playback.
Slide Show
Sets the display time for the still
picture (in JPEG format) playback 5sec*
10sec
DivX(R) VOD
Provides DivX
® VOD registration
code.
For more information about DivX ® VOD visit
www.divx.com/vod
Others
Angle Icon
Screen Saver
Auto Power Off
Panel Display
Slide Show
DivX(R) VOD
Closed Caption
Off
On
On
Bright
5sec
Off
Others
Power Saving
Remote Control Setting
Media Select
On
BD1
Disc
Setting items Options
Closed Caption
Sets whether display the closed
caption or not using the caption
decoder (commercially available ). On
Off*
Power Saving
Lower the power consumption for
standby mode by denying the
command from RS-232C during
standby mode. On*:
Denies the command from RS-232C when the power is
in standby mode.
Off:
Accepts the command from RS-232C when the power is
in standby mode.
Remote Control Setting
Changes the signal code of a
remote control. (Refer to page 6) BD1*
BD2
Media Select
Select the media to playback. Disc*:
Select this when you play back a disc.
SD Memory:
Select this when you play back a SD Memory Card.
Initialize
Note
• The setting for “Ratings” will not be reset.
Initialize
Initialize?
No
Setup
Memory Device
E5E30UD_EN.book Page 37 Thursday, May 22, 2008 3:43 PM