Multi-Tech Systems RF802EW User Manual
Page 17
17
Chapter 3 - Software Installation and Configuration
Record the values presented in the Device Information panel for later reference.
Device IP Address ______________________
Device MAC Address ____________________
Device Firmware Version _________________
Click Next.
Note: If a message appears indicating the device is not found, or you do not see the device
you are attempting to configure listed, click Refresh Device List.
6.
The Setup Wizard: Device IP Address dialog box displays.
•
Enter your local internal network’s IP address for this device.
The Setup Wizard will automatically detect the first three octets of your local IP address. You
must enter the last octet only.
•
If you wish, you can change the network name of your RouteFinder. If your ISP requires
your device to have a name, you may use the name entered here.
•
Click Next to continue. The device will search the network to ensure that the IP address is
valid. This may take several seconds.
Note: If your ISP provided you with an IP address, do not enter that address. Enter the IP
address for this device on your local network. Refer to the Glossary for additional
information on IP addressing.
7.
The Wireless Function dialog box displays.
Select the function for the wireless port function by selecting Enable Wireless Access Point