Multi-Tech Systems RF802EW - Manual (Page 46)

46
Chapter 5 - RouteFinder Manager
Individual Port Options
Individual Port Options lets you set the idle-timeout function for each serial port of the RouteFinder.
You can set the number of minutes you wish to allow a connection to stay idle before disconnection.
Note: Default idle timeout for IP Routing is 5 minutes. Default idle timeout for Remote Access is 30
minutes.
If you un-check the idle-timeout, once a client establishes a connection, the connection will be
maintained until you turn off your modem, unplug your network device or use the Terminate
Connection function in the RouteFinder monitor program.
The Automatic Reconnect (Always connect) essentially maintains your connection (idle time out =
infinite). If the connection is disconnected for any reason, it will automatically attempt to reconnect.
Dial-up Retry Options
The Dial-Up Retry option allows you to specify the number of times the RouteFinder should attempt
to establish a connection.
If the retry count is 0, the device will not dial-out to connect to the remote site.
Note: Automatic Reconnect will override the Retry count setting if retry count is set to 0.
LAN DHCP Server
Note: Refer to the Glossary at the back of this User Guide for more information about the DHCP
function.
1. From the main Manager dialog box, click LAN DHCP Server.
Note: The LAN DHCP Server option indicates if DHCP is Enabled or Disabled. By default the
DHCP function is Enabled. To Disable the function, you must open the DHCP Configuration
dialog box, select Disabled and click OK.
2. The DHCP Configuration dialog box displays.
3. Complete the following information:
DNS IP Address
Enter the ISP’s DNS IP address. You may enter up to four ISP DNS IP addresses. Click Insert.