Multi-Tech Systems RF802EW - Manual (Page 18)

18
Chapter 3 - Software Installation and Configuration
function only, or Enable Wireless Access Point + Router function. If you are using NAT
Enabled, you may also select Enable PPPoE.
• Select Enable Wireless Access Point function only to set AP’s IP manually or acquire
an IP address from a DCHP server.
• Select IP Routing (NAT Disabled) to allow the RF802EW to function as a router
between the IP segment of the server and another IP segment. This option is ideal for
organizations needing to segment workgroups.
• Select Enable PPPoE to use the RF802EW with a time-base, rather than fixed-cost DSL
modem connection. Enter the User Name and Password provided by your ISP. This
option is most often used when connecting via DSL to the Internet.
Note: Enable PPPoE is valid only when IP Routing (NAT Enabled) is selected.
Click Next.accessing the Internet. This option is most often used when the RF802EW is
connected to a DSL or cable modem, or when the IP segment of the server needs
firewall protection.
8. The Wireless Settings dialog box displays.
In the ESSID box, enter the wireless ID. Wireless is the default ID. From the Channel list, select
a channel. 6 is the default channel. All workstations must have the same ESSID Make sure that
the channel is correct for your network.
Click Next.
9. The Select Function dialog box displays.
Select IP Routing (NAT Disabled) to allow the RF802EW to function as a router between IP
segments. This option is ideal for organizations needing to segment workgroups.