Multi-Tech Systems RF802EW - Manual (Page 8)

8
Chapter 1 - Introduction
Front Panel
RF802EW Front Panel
Front Panel Description
Link Lights when the LAN client is correctly connected to the 10/100 LAN.
ACT Blinks when transmitting or receiving packets.
LAN Lights when a successful connection to the 10/100 LAN is established.
WLS Lights when a wireless connection is established.
Serial Lights when the Serial async port is properly connected to a remote site.
WAN Lights when a successful connection to the 10Base-T WAN is established.
Status Blinks when updating flash ROM or rebooting.
Power Lights when power is being supplied to the router.
Back Panel
RF802EW Back Panel
Back Panel Description
Power 5VDC The 5V DC power socket is used to connect the device to the AC power
adapter.
10 BT WAN The WAN port is used to connect the router to a DSL or Cable modem.
SERIAL The Serial async port connects the router to a standard modem (optional).
10/100M Connects the Router to a 10/100 Base-T Ethernet LAN.
Reset Press and hold for three seconds to reset the router to factory defaults.
Uplink/Normal Slide the switch to the Uplink position to use the LAN port to expand your
network by connecting a network cable to another router, switch, or hub. To
connect the port to a LAN client workstation, slide the switch to the Normal
position.