Chapter 4 - commands – Multi-Tech Systems MT2834BLR User Manual
Page 42
42
Chapter 4 - Commands
DEFAULT:
X0
DESCRIPTION:
X0 selects Basic Result Codes (w/o CONNECT 1200,
CONNECT 2400).
X1 selects Extended Result Codes (w/CONNECT 1200,
CONNECT 2400).
X2 selects Standard AT Command set with NO DIAL
TONE.
X3 selects Standard AT Command set with BUSY.
X4 selects Standard AT Command set with NO DIAL
TONE and BUSY.
COMMAND:
#Xn
VALUES:
n = 0 or 1
DEFAULT:
#X0
DESCRIPTION:
#X0 selects single XOFF character sent until XON level
returns.
#X1 selects multiple XOFF characters after buffer level is
full.
COMMAND:
Yn
VALUES:
n = 0 or 1
DEFAULT:
Y0
DESCRIPTION:
Y0 disables sending or responding to long space “break”.
Y1 enables sending or responding to long space “breaks”.
COMMAND:
Z
VALUES:
n/a
DEFAULT:
n/a
DESCRIPTION:
All configuration parameters are reset to default values.
COMMAND:
, (Comma)
VALUES:
n/a
DEFAULT:
n/a
DESCRIPTION:
Causes pause during dialing.
COMMAND:
;(Semi-Colon)
VALUES:
n/a
DEFAULT:
n/a
DESCRIPTION:
Causes return to Command Mode after dialing.
COMMAND:
! (Exclamation)
VALUES:
n/a
DEFAULT:
n/a
DESCRIPTION:
Causes modem to flash On-Hook.
COMMAND:
@
VALUES:
n/a