Multi-Tech Systems MT2834BLR - Manual (Page 46)

46
Chapter 4 - Commands
You can now use any AT commands of the modem being remotely
configured as if they were being entered locally. You cannot change the
Set-up of the LOGIN Password until you enter the proper LOGIN
Password.
4. When you are done entering AT commands and you want to exit, type
AT0 and hit RETURN. The modem responds with:
1. DATA Mode
2. COMMAND Mode
5. Enter a 1 to go back on-line with your computer, or enter 2 and the
correct password to talk to your modem.
Password Commands
COMMAND: #Ixxxxxxxxxx
VALUES: n/a
DEFAULT: #IMULTITECH
DESCRIPTION: Login Password is any keyboard characters (x) (upper/
lower case sensitive), minimum 6 and maximum 10
characters. The default Login Password is MULTI-TECH.
COMMAND: #Syyyyyyyyyy
VALUES: n/a
DEFAULT: #SMODEMSETUP
DESCRIPTION: Set-up Password is any keyboard characters (y) (upper/
lower case sensitive), minimum 6 and maximum 10
characters. The default Set-up Password is
MODEMSETUP.
4.1.4 V.25bis Commands
COMMAND: $Vn
VALUES: n= 0, 1, 2, 5, or 6
DEFAULT: $V0
DESCRIPTION: $V0 returns modem to AT command mode when in V.25bis
mode.
$V1 enables V.25bis mode of operation.
$V2 allows modem to receive one V.25bis command while
in AT command mode without leaving AT command mode.
$V5 DSR follows DTR in V.25bis mode.
$V6 DSR does not follow DTR in V.25bis mode.