Multi-Tech Systems MT2834BLR - Manual (Page 45)

45
Chapter 4 - Commands
4.1.2 Remote Configuration
The Remote Configuration feature is a network management tool that
allows you to configure modems remotely. This means you could configure
modems anywhere in your network from one location without having to visit
the sites or rely on remote users to follow your instructions. With Remote
Configuration, which is protected by two level security, you can downline
load new parameters, program new V.42 capabilities and implement new
features. Remote Configuration also makes troubleshooting a remote
location a lot easier.
The way Remote Configuration works is that S-Register S13 has been set-
up to contain the special Remote Configuration escape code. When
calling a Remote Configuration equipped modem, you enter the proper
Remote Escape code to enable entering your Set-up Password. After
entering it, you can then execute AT commands as if you were connected
locally. If you set S-Register S13 to zero, Remote Configuration is
disabled.
4.1.3 Remote Configuration Procedures
The procedures for using the Remote Configuration features are the same
whether or not a call originates from the remote modem. Once the modem
is on-line, perform the procedure below.
1. Remote Escape Configuration requires %%%<CR> to be sent if the
default value in S-Register S13 has not been changed. The modem
responds with:
1. - DATA Mode
2. - COMMAND Mode
2. You then select 1 or 2. With 1, the modem goes back into data mode
and with 2, the modem responds with the following:
Password>
3. Enter your Set-up Password, and if the code is correct the modem
responds with:
OK