Auto repeater function – Icom IC-U82 User Manual
Page 32
20
5
REPEATER OPERATION
The USA/CSA versions automatically activate the repeater
settings (duplex ON/OFF, duplex direction, tone encoder
ON/OFF) when the operating frequency falls within or outside
of the general repeater output frequency range. The offset
and repeater tone frequencies are not changed by the auto
repeater function. Reset these frequencies, if necessary.
q While pushing and holding
[
Y
Y
]
and
[
Z
Z
]
, turn the power ON
to enter
INITIAL SET MODE
.
w Push
[
Y
Y
]
or
[
Z
Z
]
several times until “RPt” appears.
e Rotate
[VOL]
to select the desired condition.
• “OF”— the auto repeater function is turned OFF;
• “R1”— the auto repeater function activates duplex only;
• “R2”— the auto repeater function activates duplex and tone.
r Push
[
✱
•
ENT
]
(or
[D•
CLR
]
) to exit
INITIAL SET MODE
.
• Frequency range and offset direction
Frequency range
Duplex direction
145.200–145.495 MHz
“–” appears
146.610–146.995 MHz
147.000–147.395 MHz
“+” appears
442.000–444.995 MHz
“+” appears
447.000–449.995 MHz
“–” appears
■
Auto repeater function
(USA/CSA versions only)
USING
INITIAL SET MODE