Icom IC-U82 - Manual (Page 34)

q Push [D• CLR ] to select VFO mode, if necessary.
w Set the desired frequency.
e Set other information, such as tone, duplex, as desired.
r Push
[A• FUNC ] , then [C• MR ] momentarily.
• “X” and memory channel number blink.
t Push [ Y Y ] or [ Z Z ] to select the desired memory channel.
• When programming the call channel, select “C.”
• When
[VOL] is assigned as tuning dial, rotate [VOL] to select
the memory channel. (pgs. 14, 65)
y Push [A• FUNC ] , then push and hold [C• MR ] for 1 sec., when
3 beeps will sound to program the information into the se-
lected memory channel and return to VFO.
• After 3 beeps are emitted, continue to hold [C• MR ] to increment
the displayed memory channel number.
MONI
CALL
DUP SCAN
PRIO ENT SET H/M/L
OPT SKIP
BANK TONE T.SCAN P.BEEP
MR CLR FUNC
PWR
9 8 7
4
1 2 3
A B D C
5 6 0
MONI
CALL
DUP SCAN
PRIO ENT SET H/M/L
OPT SKIP
BANK TONE T.SCAN P.BEEP
MR CLR FUNC
PWR
9 8 7
4
1 2 3
A B D C
5 6 0 MR
FUNC
A
C
MONI
CALL
DUP SCAN
PRIO ENT SET H/M/L
OPT SKIP
BANK TONE T.SCAN P.BEEP
MR CLR FUNC
PWR
9 8 7
4
1 2 3
A B D C
5 6 0
MONI
CALL
DUP SCAN
PRIO ENT SET H/M/L
OPT SKIP
BANK TONE T.SCAN P.BEEP
MR CLR FUNC
PWR
9 8 7
4
1 2 3
A B D C
5 6 0 MR
FUNC
A
C
■
Programming the memory/call channels
22
6
MEMORY/CALL OPERATION