Pager operation – Icom IC-U82 User Manual
Page 52
40
10
PAGER/CODE SQUELCH
■
Pager operation
D
Calling a specific station
q Program the code channel in advance (p. 39).
w Set the operating frequency.
• Set the volume and squelch to the desired level as in normal op-
eration.
e Push
[A•
FUNC
]
, then push
[0•
OPT
]
.
• Rotate
[VOL]
to select “dtm.PG,” if “dtm.CS” or “dtm.OF” ap-
pears.
r Select the desired transmit code channel:
➥ Push and hold
[0•
OPT
]
for 1 sec. to enter the code se-
lection mode.
➥ Rotate
[VOL]
to select the desired code channel.
➥ Push
[
✱
•
ENT
]
to return to previous mode.
• 100 MHz digit shows “P.”
t Push
[PTT]
to transmit the pager code.
y Wait for an answer back.
• When the transceiver receives an answer back code, the func-
tion display shows the other member’s ID or group code.
u After confirming a connection, push
[A•
FUNC
]
and
[0•
OPT
]
to enter
OPTION SET MODE
, then rotate
[VOL]
to select the
code squelch operation “dtm.CS,” or non-selective calling
system “dtm.OF.”
• DO NOT push any digit keys while code channels C0 to C6 are
displayed, otherwise code channel contents will be changed.
i Communicate with the other party as normal: push
[PTT]
to transmit; release to receive.
D
Waiting for a call from a specific station
q Set the operating frequency.
w Push
[A•
FUNC
]
, then push
[0•
OPT
]
.
➥ Rotate
[VOL]
to select “dtm.PG,” if “dtm.CS” or
“dtm.OF” appears.
➥ Push
[
✱
•
ENT
]
to return to previous mode.
• 100 MHz digit shows “P.”
e Wait for a call.
• When receiving a call, the caller’s ID or group code appears as
shown at next page.
• DO NOT push any digit keys while code channels C0 to C6 are
displayed, otherwise code channel contents will be changed.
r Push
[PTT]
to send an answer back call and display the
operating frequency.
t After confirming a connection, push
[A•
FUNC
]
and
[0•
OPT
]
to enter
OPTION SET MODE
, then rotate
[VOL]
to select the
code squelch operation “dtm.CS,” or non-selective calling
system “dtm.OF.”