JVC BR-DV600AE - Manual (Page 15)

E-15
DV IN/OUT
AUDIO VIDEO
LINE Y/C CH 1/3 CH 2/4
IN
OUT
REMOTE
SERIAL 9PIN
NTSC/PAL
NTSC PAL
DC12V
! 6 5
8 7
9
0
5
[VIDEO Y/C IN] Video Y/C input
terminal (4P)
This is the input terminal for YC separate video signals.
● To input video signals from this terminal,
set the INPUT SEL. switch on the front panel
to “Y/C”.
● When Wide discriminating signals are in-
put, ID signals for Wide discriminating sig-
nals are recorded.
6 [VIDEO LINE IN] Video line input
terminal (RCA)
This is the input terminal for composite video
signals.
● To input video signals from this terminal,
set the INPUT SEL. switch on the front panel
to “LINE”.
7 [VIDEO Y/C OUT] Video Y/C output
terminal (4P)
This is the output terminal for YC separate video
signals.
When tapes recorded with Wide discriminating
signals are played, ID signals for discriminating
signals are output.
8 [VIDEO LINE OUT] Video line out-
put terminal (RCA)
This is the output terminal for composite video signals.
Memo
● Besides video signals, the following signals from
the VIDEO Y/C OUT terminal and VIDEO LINE
OUT terminal are displayed on-screen.
• Menu screen signals
• Character display of date, time or operation
modes (Status screen)
By pressing the DISPLAY button on the wireless
remote controller or by setting the DISPLAY item
in the DISPLAY menu, the user can choose to
turn the status display on/off.
● The SETUP item of the AUDIO/VIDEO menu can
be set to determine whether setup will be added
to the signals of VIDEO Y/C OUT terminal and
VIDEO LINE OUT terminal. (NTSC only)
9
[AUDIO IN] Audio input terminal
(RCA
ן2)
This is the audio signal (analogue) input termi-
nal.
For audio dubbing, sounds from the CH1/3 ter-
minal are recorded on the CH3 channel while
those from the CH2/4 channel are recorded on
the CH4 channel.
Memo
● When the MIC terminal on the front panel is con-
nected to a microphone, sounds from this termi-
nal will not be recorded.
0 [AUDIO OUT] Audio output terminal
(RCA
ן2)
This is the audio signal (analogue) output ter-
minal.
Memo
● The audio channel to play back tapes recorded in
the 32K mode can be selected with the OUT SE-
LECT button on the wireless remote controller or
by setting the AUDIO OUT SEL. item of the AU-
DIO/VIDEO menu.
● The output level of the playback audio can be se-
lected with the OUT LEVEL button of the wireless
remote controller or by setting the AUDIO OUT
LEVEL item of the AUDIO/VIDEO menu (NORMAL
or ATT).
! [DV IN/OUT] DV input/output terminal
This is the input/output terminal for digital sig-
nals of IEEE1394 standard. It is connected to
video devices with DV terminals.
● To input signals from this terminal, please set
the INPUT SEL. switch on the front panel to
“DV”.
● Signals from this terminal are output regard-
less of the INPUT SEL. switch setting.
BR-DV3000_E_p03-49 06.8.24, 1:38 PM 15