JVC BR-DV600AE - Manual (Page 47)

E-47
PLAYBACK
–
Locate function
–
Index search
This function locates and advances/rewinds to the position where the index signal is recorded.
Use the remote controller.
Ⅵ To locate an index in the forward direction vis-a-vis the
current tape position:
• Press the INDEX + button.
The index position to be located can be specified by the number
of times this button is pressed. (Max: 99)
Ⅵ To locate an index in the reverse direction vis-a-vis the
current tape position:
• Press the INDEX - button.
The index position to be located can be specified by the number
of times this button is pressed. (Max: 99)
Ⅵ When the INDEX + or INDEX - button is pressed, the unit
will fast-forward or rewind to the specified indexed po-
sition and start playing.
A.DUB
F.REV
INDEX– INDEX+
PLAY
STOP
REMOTE CONTROL UNIT
RM-G3000
REW FF
PAUSE REC
F.ADV
INDEX –
button INDEX +
button
Blank search
This function locates the unrecorded parts of the tape. Use the remote controller.
INDEX+1
During index search, this message
is displayed on the monitor
(the number represents the position of
the index).
DISPLAY
BARS
MENU SEARCH+
BLANK
STILL
MODE
AUDIO
MUTING
OUT SEL.
BLANK button
BLANK SEARCH
Monitor screen
Memo
• If the interval between index signals is less than 1 minute, the function
may not work well.
• The specifications for index signal recording varies with the device used.
Monitor screen
Ⅵ In the STOP mode, press the BLANK button.
• If the current position is at a recorded part of the tape, the unit
fast-forwards until an unrecorded part is reached and goes into
the STOP mode.
• If the current position of the tape is unrecorded, the unit will first
advance the tape in the forward direction for confirmation and
thereafter rewind and go into the STILL mode at the last recorded
position.
• During a blank search, “BLANK SEARCH” is displayed on the
monitor.
BR-DV3000_E_p03-49 06.8.24, 1:39 PM 47