Sun Microsystems StorEdge 6900 Series - Manual (Page 155)

Appendix B SUNWsecfg Error Messages 139
restoret3config Error while the block size compare
command is executing. The
$BRICK_IP{$IPADD} command is
aborted.
The Sun StorEdge T3+ array block size
parameter is different from the
snapshot file. The Sun StorEdge T3+
array may have been reconfigured.
Run
restoret3config .
restoret3config $LUN configuration failed to restore
and the force option was used to
reinitialize, without success
Check the Sun StorEdge T3+
configuration with the
showt3 -n
t3_name command. Restore the Sun
StorEdge T3+ array configuration with
the
restoret3config command.
restoret3config $LUN configuration is not found in the
$restore_file . Cannot restore
$LUN .
Check for snapshot files in the
/opt/SUNWsecfg/etc/t3_name/
directory. If the snapshot files are not
found, use the modifyt3config
command to configure the Sun
StorEdge T3+ array.
savet3config While checking the configuration, the
Sun StorEdge T3+ array configuration
has not been saved. Check the Sun StorEdge T3+ array
configuration by using the
showt3 -n
t3_name command, if the
configuration is different from
standard Sun StorEdge T3
configurations. Use the
modifyt3config command to
reconfigure the device.
TABLE B-3 Sun StorEdge T3+ Array SUNWsecfg Error Messages (Continued)
Message Description and Cause of Error Suggested Action