SOYO SY-6IWM - Manual (Page 33)

Hardware Installation SY-6IWM
29
2. Reset
Plug the Reset push-button cable into the 2-pin Reset header on the Motherboard.
Pushing the Reset button on the front panel will cause the system to restart the
boot-up sequence.
3. Speaker
Attach the 4-pin PC speaker cable from the case to the Speaker header on the
Motherboard.
4. ACPI LED
Connecting the 2-pin ACPI LED cable to the corresponding ACPI LED header
will cause the LED to light whenever the system is in ACPI mode.
The manufacturer has permanently set this Motherboard in ACPI mode due to
most hardware and software compliance to ACPI mode.
Reset Pin Assignment
Power Good GND
1
Speaker Pin Assignment
+
_
+5V Speaker out NC NC
ACPI LED Pin Assignment
+
_
LED Anode LED Cathode