SOYO SY-6IWM - Manual (Page 50)

Hardware Installation SY-6IWM
46
2-3.6 Power On
You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system is
performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up sequence
is completed. Then push the RESET button and press <DEL> key again at
the beginning of boot-up, during diagnostic checks.
Repeat this operation until you get the following screen.
3. The BIOS Setup screen appears:
CMOS Setup Utility – Copyright ( C ) 1984-1999 Award Software
4Soyo Combo Feature 4PC Health Status
4Standard CMOS Features Load Optimized Defaults
4Advanced BIOS Features Load Fail - Safe Defaults
4Advanced Chipset Features Set Supervisor Password
4Integrated Peripherals Set User Password
4Power Management Setup
Save & Exit Setup
4PnP/PCI Configurations Exit Without Saving
Esc : Quit
бваЯ : Select Item
F10 : Save & Exit Setup
Change CPU’s Clock & Voltage