SOYO SY-6IWM - Manual (Page 47)

Hardware Installation SY-6IWM
43
2-3.4 Jumper Setting
Step 1.
Enable/Disable Power-On by Keyboard (JP1)
You may choose to enable the Power-On through Keyboard function by shorting
pin 1-2 on jumper JP1; or short pin 2-3 to disable this function.
Power-On by
Keyboard
Enable Disable
JP1 Setting
Short pin 1-2 to
enable the Power-
On by Keyboard
function.
Short pin 2-3 and
the Power-On by
Keyboard function
is disabled.
Important: When using the Power-On by Keyboard function, please make
sure the ATX power supply is able to provide at least 720mA on the 5V
Standby lead (5VSB) in order to meet the standard ATX specification.
Step 2.
Set JP9 for hardware Write-Protect
This jumper sets FWH (Firm Ware Hub or BIOS) Write-protect when open, Short
JP9 ONLY when the BIOS needs to be upgraded.
The Hardware Write-
Protect
Locked Unlocked
JP9 Setting open JP9 short JP9
Step 3.
Set JP2, JP3,JP4 and JP7 to configure CPU FSB
Frequency
The FSB Frequency can be set through the BIOS [SOYO COMBO SETUP]. The
BIOS will allow selection from 1 out of 3 intervals. The intervals are: - 66 to
100MHz
- 100 to 133MHz
- 133Mhz and above
What interval can be selected from depends on the jumper setting on the board.
Ø CPU Default or Free Selection
Ø CPU frequency indication
1 2 3 1 2 3
1 2
1 2