SOYO SY-6IWM - Manual (Page 40)

Hardware Installation SY-6IWM
36
3. Infrared (IR1)
Plug the 5-pin infrared device cable to the IR1 header. This will enable the infrared
transfer function. This Motherboard meets both the ASKIR and HPSIR
specifications.
Please install according to the following pin assignment:
4. CD Line-in (J9)
This Motherboard provides two CD-Line in connectors. Please connect the 4-pin
audio cable from your CD-ROM drive to either J9. (It fits in only one, depending
on the cable that came with your CD-ROM drive)
Please install according to the following pin assignment:
Serial Infrared (IR1) Connector
IR1 Pin Assignment
1 2 3 4 5
VCC
IRRX
GND
IRTX
CD-IN: J9
Right
Left
GND
GND
1 2 3 4