Sherwood RD-8504 - Manual (Page 17)

E
N
G
L
IS
H
17
LoADInG BAtteRIes
oPeRAtInG coMPonents WItH ReMote contRoL ReMote contRoL oPeRAtIon RAnGe
• Use the remote control within a range of about 7 meters
(23 feet) and angles of up to 30 degrees aiming at the
remote sensor.
• In such a case that some components do not have the
REMOTE SENSOR which receives the remote signals,
this remote control cannot operate them.
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several
minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared. Should
this happen, you should memorize them again.
• Remove the batteries when they are not used for a long
time.
• Do not use the rechargeable batteries (Ni-Cd type).
• Be sure to use alkaline batteries.
1.
Enter the setup code for each component other
than this receiver. For details, refer to "Entering
a setup code" on page 18.
2.
Turn on the component you want to operate.
1.
Remove the cover.
2.
Load two batteries ("AAA" size, 1.5V) matching
the polarity.
3.
Press the DEVICE button on the remote control
corresponding to the component you wish to
operate.
4.
Aim the remote control at the REMOTE
SENSOR of the component you wish to control
and press the button corresponding to the
operation you want.
RD-8504(A)_ENG_091118:RD-8504(A) 2009-11-18 오 6:41 페이지 17