Sherwood RD-8504 - Manual (Page 26)

E
N
G
L
IS
H
26
Continued
■To cancel the surround mode for stereo operation
■2CH downmix mode
• This mode allows the multi-channel signals encoded in DTS or Dolby Digital format, etc. to be mixed down into 2 front
channels and to be reproduced through only two front speakers or through headphones.
• When the SPEAKER button is set to off to listen with headphones while playing the multi-channel digital signals from DTS or
Dolby Digital sources, etc., it will enter the 2CH downmix mode automatically.
• The volume level of each channel can be adjusted easily with the test tone function.
■
Note : When the SPEAKER button is set to off, the test tone function does not work.
Adjusting each channel level with test tone
• The test tone mode is displayed and will be heard from the
speaker of each channel for 2 seconds as follows:
→ FL → C → FR → SR
Front Left Center Front Right Surround Right
SUB
← SL ( ←
SB ) or ( SBL
← SBR) ←
Subwoofer Surround Left Surround Back Surr.Back Left Surr.Back Right
• When the speaker setting is "No", the test tone of the
corresponding channel is not available.
• ( ) : Possible depending on whether the surround back
channel is set to "2 Channel" or "1 Channel (Left)".
• You can select the desired channel with
pressing the CONTROL UP/DOWN buttons
or the CURSOR UP/DOWN buttons.
1.
Enter the test tone mode.
3.
Cancel the test tone function.
2.
At each channel, adjust the level as desired until the sound level of each speaker is heard to be equally loud.
• Depending on the signal format which is being input,
either the stereo mode or the 2CH downmix mode is
selected.
• To cancel either the stereo mode or the 2CH
downmix mode, select the surround mode with using
the MULTI CONTROL knob on the front panel or the
SURROUND MODE UP/DOWN (
〉 /〈) buttons on the
remote control.
RD-8504(A)_ENG_091118:RD-8504(A) 2009-11-18 오 6:41 페이지 26