Sherwood RD-8504 - Manual (Page 33)

E
N
G
L
IS
H
33
E
N
G
L
IS
H
• You can display SIRIUS information such as channel
name, artist name, song title and signal strength.
• In the SIRIUS mode,
Displaying SIRIUS information
• Each time the DISPLAY button is pressed, the display
mode changes as follows:
→ Channel name → Song title → Artist name → Composer name
Volume ← Surround mode ← Signal input ← Signal strength ← Category ←
("EXCEL(LENT)", "GOOD", "WEAK", "NO SIG(NAL)")
■Note:
• If the information on artist name, song title or category, etc.
is not available, it will not be displayed correctly.
■Signal strength display mode
• If the reception is poor, you can check the signal strength of
the SIRIUS Satellite Radio signal and adjust the position of
the SiriusConnect Home antenna until "EXCEL(LENT)" is
displayed.
■Error message and status
• If an operation takes longer than usual or an error occurs,
one of the following messages may be displayed.
Message
ANTENNA
UPDATING
SUB-UPDT
(updated)
NO SIG(NAL)
LINKING
CHECK SR
TUNER
Status
The SiriusConnect Home tuner is not
connected properly. Check it.
Displayed while the encoding code is
being updated. Please wait.
Displayed while updating contract
information. Please wait.
The signal cannot be received.
Reposition your SiriusConnect Home
Tuner antenna.
The selected channel is not currently
broadcasting. Select another channel.
The SiriusConnect Home tuner is not
connected properly. Check it.
■When tuning in the previously locked channels.
① Tune in the channels to which the parental lock is applied
by performing direct search or preset search only.
• Then "CODE " is displayed for several seconds.
② While displaying "CODE ", input the password
(4-digit number) with using the NUMERIC (0~9) buttons.
• When you input the correct code, the current channel can
be heard(, not be unlocked).
• If the wrong password is input, "CODE ERR(OR)" is
displayed. In this case, input the password again by
performing the steps
① and ②.
• When "CODE " disappears, repeat again from the
above step
①.
2.
Press and hold down the ENTER button for more
than 3 seconds.
1.
Tune in the channel you want to lock or unlock.
• You can lock the channels that you do not want to receive
or unlock the previously locked channels.
Parental lock
3.
Press the CURSOR UP/DOWN buttons to select
the “PARENTAL” (Parental lock), then press the
ENTER button.
• Then "CODE " is displayed for several seconds.
• Each time the CURSOR UP/DOWN buttons are pressed,
“EDIT CODE” or “PARENTAL” is selected.
• Then “EDIT CODE” (Edit lock code) is displayed for
several seconds.
RD-8504(A)_ENG_091118:RD-8504(A) 2009-11-18 오 6:41 페이지 33