Sherwood RD-8504 - Manual (Page 51)

51
• You can adjust the crossover frequency within the range of 40 ~ 250 Hz.
• Select "Full Range" when the selected speaker can fully reproduce the low frequencies below 40 Hz.
• When the CURSOR LEFT button is pressed on the setting menu, the previous menu will be returned to.
When selecting the Speaker Crossover
■Note :
• You cannot select the subwoofer and the speakers set to "No".
• Set the crossover frequency according to the frequency characteristics of the speakers connected.
(For details on the frequency characteristics, refer to the operating instructions of the speakers.)
• If the frequency range of your speaker is 100 Hz ~ 20 kHz, the crossover frequency should be set to 100 Hz (or slightly
higher).
• The low frequencies below the crossover frequency are to output from subwoofer or the speakers which are set to "Full
Range" (when not using a subwoofer).
1.
Press the CURSOR UP/DOWN buttons to select the Speaker X-over, then press the CURSOR RIGHT button
to enter the setting menu.
2.
Press the CURSOR UP/DOWN buttons to select the desired speaker, then press the CURSOR RIGHT
button to enter its setting menu.
3.
Press the CURSOR UP/DOWN buttons to set the crossover frequency as desired, then press the ENTER
button.
4.
Repeat the above steps 2 and 3 until the crossover frequencies are all set as desired.
E
N
G
L
IS
H
Front
Center
Surround
Surr Back BACK NEXT
RD-8504(A)_ENG_091118:RD-8504(A) 2009-11-18 오 6:41 페이지 51