Sherwood RD-8504 - Manual (Page 36)

E
N
G
L
IS
H
36
DIGITAL AUDIO RECORDING WITH MD RECORDER
• Only when the OPTICAL DIGITAL OUT of this receiver
is connected to the OPTICAL DIGITAL IN of the MD
recorder or CD recorder, you can enjoy high-quality
sound of digital recording without converting the original
signals. Refer to "CONNECTING VIDEO
COMPONENTS", "CONNECTING AUDIO
COMPONENTS" and "CONNECTING DIGITAL INS
AND OUT" on pages 6 ~8 and the operating instructions
of the MD recorder or CD recorder.
■
Notes:
• The digital audio signals input into the OPTICAL and the
COAXIAL DIGITAL INs (, not the HDMI INs) can be
output from the OPTICAL DIGITAL OUT.
• Depending on the digital audio signal format, some
digital signals cannot be output from the OPTICAL
DIGITAL OUT.
• Digital recording is available for the digital audio
program sources such as CDs, MDs, some DVDs, etc.
• There are some restrictions on recording digital signals.
When making digital recordings, refer to the operating
instructions of your digital recording equipment to know
what restrictions are imposed.
1.
Select the desired of CD, F.AUX, VIDEO 1~3,
EXT.IN as a recording source.
2.
For digital recording, select the digital input as
recording signal input.
3.
Start recording on the component connected to
the OPTICAL DIGITAL OUT.
4.
Start play on the desired input.
■
Note :
• If the Audio Mode is set to the mode other than "Digital"
for the corresponding recording source on the INPUT
SETUP menu, the digital audio signals from the selected
digital input will not be output and there will be no
recording. (For details, refer to "When CD, F.AUX,
VIDEO 1~3, EXT.IN is selected as an input source" on
page 22 and "When selecting the Audio Mode" on page
57.)
RD-8504(A)_ENG_091118:RD-8504(A) 2009-11-18 오 6:41 페이지 36