Sherwood RD-8504 User Manual
Page 38
E
N
G
L
IS
H
38
ROOM 2 SOURCE PLAYBACk
• This function allows enjoying one source in the main room and playing another in a different room at the same time.
■Notes:
• The analog signals from the EXTERNAL INs and the digital signals cannot be output to the different room, meaning no
playback in a different room.
• Only the (composite) video signals can be output to the different room.
• When the EXTERNAL IN is selected as a main input, if the MAIN source is selected as a ROOM 2 input, no audio signal can be
heard in the different room (ROOM 2).
• Even when this receiver enters the standby mode, in such a case that only the "R2" lights up still, meaning only the ROOM 2
circuitry operates, the ROOM 2 source can be played independently.
• When you do not use the ROOM 2 function, turn off the ROOM 2 function to save electricity.
• ROOM 2 ~ is displayed for several seconds.
• When the ROOM 2 setting mode disappears, press the
ROOM 2 button again.
• Each time these buttons are pressed, the mode changes
as follows :
→ ROOM 2 ~ : To turn on or off the ROOM 2 function.
(ROOM 2 mode)
↕
IN ~ : To select the desired ROOM 2 source.
(ROOM 2 input)
↕
→ VOL ~ : To adjust the volume on the power
(ROOM 2 volume)
amplifier assigned to "Surr Back
↔
Room 2" or "Room 2".
■Note :
• When the ROOM 2 mode is set to OFF, the ROOM 2 input
and the ROOM 2 volume cannot be selected.
■When selecting the ROOM 2 mode.
ON : To turn on the ROOM 2 function.
↕ ("R2" lights up.)
OFF : To turn it off. ("R2" goes off.)
1.
Press the ROOM 2 button to enter the ROOM 2 mode.
3.
Set the selected mode as desired.
4.
Start play on the component related to the ROOM 2 source.
2.
Select the desired mode while displaying the ROOM 2 setting mode.
When using the buttons on the front panel
■When selecting the ROOM 2 input.
• You can select the desired among MAIN source, TUNER, CD, F.AUX, TAPE, BT (Bluetooth IN), VIDEO 1 ~ VIDEO 3 as a
ROOM 2 source.
■When selecting the ROOM 2 volume.
• You can adjust the volume on the power amplifier assigned to "Surr Back
↔Room 2" or "Room 2" when the ROOM 2
speaker terminals are connected to the speakers in a different room. (For details, refer to "When selecting the AMP Assign"
on page 45.)
RD-8504(A)_ENG_091118:RD-8504(A) 2009-11-18 오 6:41 페이지 38