Sanyo PLC-WL2503 - Manual (Page 22)

22
Menu Bar
For detailed functions of each menu, see “Menu Tree” on pages 68-69.
①
②
③
④
⑤
⑥
⑦
⑧
Main Menu Sub-Menu
⑨
⑩
③ Image select
For computer source, used to select an image mode from among Dynamic, Standard, Real, Blackboard(Green),
Colorboard and Image 1-4. (p.33)
For video or HDMI source, used to select an image mode among Dynamic, Standard, Cinema, Blackboard(Green),
Colorboard and Image 1-4. (p.40)
④ Image adjust
For computer source, used to adjust computer image [ Contrast, Brightness, Color temp ., White balance (Red/Green/
Blue), Sharpness and Gamma]. (pp.34-35)
For video or HDMI source, used to adjust picture image [ Contrast, Brightness, Color, Tint, Color temp ., White
balance (Red/Green/Blue), Sharpness, Gamma, Noise reduction and Progressive]. (pp.41-42)
② PC adjust
Select Auto PC adj ., Fine sync, Total dots, Horizontal, Vertical, Current mode, Clamp, Display area H and Display
area V to adjust the parameters to match with the PC input signal format. (pp.34-35)
⑤ Screen
For computer source, used to adjust size of the image [ Normal, True, Full, Custom and Digital zoom +/– ]. (pp.35-36)
For video or HDMI source, used to set size of image [ Normal, Full, Zoom, Wide, Natural wide and Custom]. (p.43)
① Input
Used to select an input source from Computer 1, Computer 2, HDMI, Video or S-video. (pp.27-28,37-38)
⑥ Sound
Used to adjust the volume or mute the sound. (p.24)
⑧ Information
Display the input source information: Input , H-sync freq ., V-sync freq ., Screen, Language, Lamp status, Lamp
counter, Power management, Key lock, PIN code lock and Remote control . (p.59)
⑩ Guide
The key operation is displayed.
⑦ Setting
Used to set the projector’s operating configurations. (pp.44-58)
⑨ Network
See owner’s manual of “Network Set-up and Operation”.
Basic Operation