Sanyo PLC-WL2503 - Manual (Page 9)

9
⑤ S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.15).
⑨ AUDIO IN
Connect the audio output signal from video
equipment connected to ⑤ or ⑩ to this jack.
For a monaural audio signal (a single audio
jack), connect it to the L (MONO) jack (p.15).
⑧ COMPUTER / COMPONENT AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to ②,
③ or ④ to this jack (pp.14,16).
⑩ VIDEO IN
Connect the composite video output signal to
this jack (p.15).
③ COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.14,16).
⑥ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.14-16).
This terminal outputs sound from AUDIO IN
terminal (⑧ or ⑨) or HDMI terminal ② (digital
audio).
① LAN Connection Terminal
Connect the LAN cable (refer to the owner’s manual
of "Network Set-up and Operation").
⑧ ⑨
⑦ CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector
with the serial control cable.
⑩
Part Names and Functions
③ ④ ② ①
② HDMI
Connect the HDMI signal from computer or video
equipment to this terminal (pp.14,16).
④ COMPUTER IN 2/MONITOR OUT
This terminal is switchable and can be used for
input from a computer or output to the other monitor.
Set the terminal up as either Computer input or
Monitor output properly. [Used for Monitor out,
this terminal outputs only incoming signal from
COMPUTER IN 1/COMPONENT IN terminal (pp.
14, 50)].
Side Terminal
is registered trademarks of HDMI
Licensing, LLC.
⑤ ⑥ ⑦