Sanyo PLC-WL2503 - Manual (Page 27)

27
HDMI
ASPECT
Choose Computer 1(RGB) by pressing the COMPUTER 1
button on the remote control or press the INPUT button on
the top control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
1
Input Menu
2
3
Input Source Selection (Computer 1: RGB)
Computer Input
COMPUTER 1 button
 Note:
When the Input Search function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.45).
Computer
1
Remote Control
Press the MENU button to display the On-Screen
Menu. Use the Point ▲ ▼ buttons to select Input and
then press the Point ► or the SELECT button.
Use the Point ▲ ▼ buttons to select Computer 1.
When Computer 1 is selected, press the Point ► to
access the submenu items. Use the Point ▲ ▼ buttons
to select the RGB input source and then press the
SELECT button.
Computer 1(RGB)
Computer 1(Scart)
Direct Operation
Menu Operation
INPUT button
Top Control
* COMPUTER 2 can not be selected when using the
COMPUTER IN 2/ MONITOR OUT terminal as MONITOR
OUT output.
Computer 1
Computer 2 *
HDMI
Video
S-video