Sanyo PLC-WL2503 - Manual (Page 30)

30
Auto PC adjustment function is provided to automatically adjust Fine sync, Total dots, Horizontal , Vertical
and Clamp position to conform to your computer.
PC adjust Menu
Auto PC adjustment
To store adjustment parameters
The adjusted parameters from the Auto PC adjustment can
be stored in the projector. Once the parameters are stored,
the setting can be done just by selecting a Mode (1-10) in
the PC System Menu (see page 29). See also “Store” on
page 32.
 Note:
• Fine sync, Total dots, Horizontal and Vertical
position of some computers can not be fully adjusted
with the Auto PC adjustment function. When the image
is not provided properly with this operation, manual
adjustments are required (pp.31-32).
• The Auto PC adjustment can not be operated when
480i, 575i, 480p, 575p, 720p, 1035i or 1080i is selected
in the PC System Menu (p.29) , or when the signal is
coming from the HDMI terminal.
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select PC adjust
and then press the Point ► or the SELECT button.
1
2
Use the Point ▲▼ buttons to select Auto PC adj . and
then press the SELECT button.
Auto PC adj .
Use Point ▲▼ buttons to select Auto PC
adj . and press the SELECT button.
Please wait . . . appears while the Auto PC
adjustment is in process.
Computer Input
Menu Operation