Sanyo PLC-WL2503 - Manual (Page 52)

52
Direct on
When this function is set to On, the projector will be automatically
turned on just by connecting the AC power cord to a wall outlet.
 Note:
Be sure to turn off the projector properly (see “Turning Off
the Projector” on page 20). If the projector is turned off in
the incorrect sequence, the Direct on function does not work
properly.
Setting
This function allows you to change the presentation of the P-timer
and execute it.
Select one of the following options:
Count up ............. The P-timer display 000:00 appears on the
screen and the count starts ( 000:00-180:00)
Count down......... The time set in the Timer setting appears on the
screen and the countdown starts.
Timer .................... Use the Point ▲▼ buttons to set the Timer
( 1-180 Min). Only set to Count down, Timer is
active. Factory default value is 10 Min.
Start ..................... It executes the count up or count down
function. Press the SELECT button at Start
and the indication changes into Stop. To stop
Count up or Count down, press the SELECT
button at Stop on the screen menu, then the
indication changes into Restart.
Reset ................... Reset the P-timer values.
Press the SELECT button at Reset to return to
the following value;
Count up ... "000:00"
Count down ... Timer that you set
Exit ....................... To exit the P-timer operation.
Stop or Cancel the P-timer via Remote Control
To stop the P-timer, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER button for a few
seconds.
P-timer
P-timer