Sanyo PLC-WL2503 - Manual (Page 28)

28
Choose Computer 2 (RGB) by press the COMPUTER 2
button on the remote control or press the INPUT button on
the top control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
 Note:
When the Input Search function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.45).
HDMI
ASPECT
COMPUTER 2 button
Remote Control
1
2
Press the MENU button to display the On-Screen
Menu. Press the Point ▲ ▼ buttons, move the highlight
to Input and then press the Point ► or the SELECT
button.
Use the Point ▲ ▼ buttons to select Computer 2 and
then press the SELECT button.
Input Menu
Computer 2 (RGB) *
3
When Computer 2 is selected, analog RGB input
source will be selected directly.
Computer Input
Input Source Selection (Computer 2: RGB)
Direct Operation
Menu Operation
INPUT button
Top Control
* COMPUTER 2 can not be selected when using
the COMPUTER IN 2/ MONITOR OUT terminal
as MONITOR OUT output.
Computer 1
Computer 2 *
HDMI
Video
S-video