Sanyo PLC-WL2503 - Manual (Page 38)

38
Choose Computer 1(Component) or Computer 1(Scart)
by pressing the the COMPONENT or COMPUTER 1 button
on the remote control or press the INPUT button on the top
control; choose HDMI by pressing the HDMI button on the
remote control or press the INPUT button on the top control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
1
Input Menu
2
Use the Point ▲▼ buttons to select Computer 1 and
then press the Point ► button; use the Point ▲▼
buttons to select Component or RGB(Scart) and then
press the SELECT button.
Input Source Selection (Component, RGB Scart 21-pin, HDMI)
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
Component
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
RGB (Scart)
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input and
then press the Point ► or the SELECT button.
 Note:
When the Input Search function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.45).
HDMI
ASPECT
COMPUTER 1 button
Remote Control
Use the Point ▲▼ buttons to select HDMI, and then
press the SELECT button;
Computer 1 (RGB)
Computer 1 (Scart)
COMPONENT button
Computer 1
(Component)
Video Input
HDMI button
HDMI
When the video signal is connected to the
HDMI terminal, select HDMI.
HDMI
Direct Operation
Menu Operation
OR
INPUT button
Top Control
Computer 1
Computer 2 *
HDMI
Video
S-video
* COMPUTER 2 can not be selected when using
the COMPUTER IN 2/ MONITOR OUT terminal
as MONITOR OUT output.