Indicators and projector condition, Projector condition, Indicators – Sanyo PLC-WL2503 User Manual
Page 70: Appendix
70
Check the indicators for projector condition.
• • • green.
• • • red
• • • off
• • • blinks green.
When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights yellow. When this
indicator lights yellow, replace the projection lamp with a new one promptly.
The projector is off. (The AC power cord is unplugged.)
The projector is in stand-by mode. Press the ON/STAND-BY button
to turn on the projector.
Projector Condition
POWER
red/green
Indicators
LAMP
REPLACE
yellow
WARNING
red
The projector is preparing for stand-by or the projection lamp is
being cooled down. The projector can not be turned on until cooling
is completed and the POWER indicator stops blinking.
The temperature inside the projector is abnormally high. The
projector can not be turned on. When the projector is cooled
down enough and the temperature returns to normal, the POWER
indicator stops blinking and the projector can be turned on. (The
WARNING indicator keeps blinking.)
The projector detects an abnormal condition and can not be turned
on. Unplug the AC power cord and plug it again to turn on the
projector. If the projector is turned off again, unplug the AC power
cord and contact the dealer or the service center for service and
checkup. Do not leave the projector on. It may cause an electric
shock or a fire hazard.
The projector is operating normally.
The projector is in the Power management mode.
The projector has been cooled down enough and the temperature
returns to normal. When turning on the projector, the WARNING
indicator stops blinking.
Indicators and Projector Condition
• • • blinks red.
Appendix