SMSC LAN91C111 - Manual (Page 128)

10/100 Non-PCI Ethernet Single Chip MAC + PHY
Datasheet
Revision 1.91 (08-18-08) 128 SMSC LAN91C111 REV C
DATASHEET
Chapter 16 Revision History
Table 16.1 Customer Revision History
REVISION LEVEL & DATE SECTION/FIGURE/ENTRY CORRECTION
Rev. 1.9
(07-17-08)
All Updated document references to Rev. C.
Rev. 1.9
(07-17-08)
Section 13.1, "Maximum
Guaranteed Ratings*," on
page 105 Fixed commercial temp range to state “0
°C to
+70
°C for LAN91C111”
Rev. 1.9
(07-17-08)
Cover Added bullet: “Commercial Temperature Range
from 0
°C to 70°C (LAN91C111)”
Rev. 1.9
(07-17-08)
Section 8.24, "Bank 3 -
Revision Register," on
page 67 Changed REV default from “0001” to “0010”
Rev. 1.9
(07-17-08)
Table 14.3, “Asynchronous
Cycle - nADS=0,” on
page 112 Changed T1A time in table under figure from 10nS
min to 2nS min.
Rev. 1.9
(07-17-08)
Section 10.4, "Typical Flow
of Event For Receive," on
page 87 In step 4, changed last sentence from “If CRC is
incorrect the packet memory is released and no
interrupt will occur.”, to “The RCV_BAD bit of the
Bank 1 Control Register controls whether or not to
generate interrupts when bad CRC packets are
received.”
Rev. 1.9
(07-17-08)
Section 7.7.14, "Receive
Polarity Correction," on
page 40 Added note at end of 10 Mbps subsection stating
“The first 3 received packets must be discarded
after the correction of a reverse polarity condition.”