SMC Networks SMC2555W-AG - Manual (Page 153)

System Management Commands
6-29
Command Usage
When SNTP client mode is enabled using the sntp-server
enable command, the sntp-server ip command specifies the
time servers from which the access point polls for time
updates. The access point will poll the time servers in the
order specified until a response is received.
Example
Related Commands
sntp-server enable (page 6-29)
show sntp (page 6-32)
sntp-server enable
This command enables SNTP client requests for time
synchronization with NTP or SNTP time servers specified by the
sntp-server ip command. Use the no form to disable SNTP
client requests.
Syntax
sntp-server enable
no sntp-server enable
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The time acquired from time servers is used to record
accurate dates and times for log events. Without SNTP, the
access point only records the time starting from the factory
default set at the last bootup (i.e., 00:14:00, January 1, 1970).
SMC-AP(config)#sntp-server ip 10.1.0.19
SMC-AP#