Siemens SE505 - Manual (Page 103)

107
Appendix
Gigaset SE505 dsl/cable / de / A31008-E505-B100-1-19 / appendix.fm / 16.07.2003
No connection to the router's
configuration environment
◆ Use the ping command to check whether you can
establish a network connection to the Gigaset
SE505 dsl/cable.
◆ Check the network cable between the PC you want
to use to administer the router and the Gigaset
SE505 dsl/cable.
◆ If the PC you want to use is on the router's local
network, make sure that you are using the correct IP
address administration (see above).
◆ If the PC you want to use is not on the router's local
network it must be authorised via Remote
Management.
Password forgotten or lost ◆ Reset the router (see page 108).
Warning: Please bear in mind that this will restore all
configuration settings to the factory settings.
You cannot access a resource
(drive or printer) on a
different PC
◆ Make sure that TCP/IP has been installed and
configured on all the PC's on the local network and
that the PC's all belong to the same workgroup.
◆ Check whether the resource has been released on
the PC in question and whether you have the
necessary access rights.
◆ Printing: Check whether the printer has been set up
as a network printer.
Symptom Possible cause and solutions