Siemens SE505 User Manual
Page 28
27
Configuring the local network
Gigaset SE505 dsl/cable / English / A31008-E505-B100-1-7619 / configure_tcpip.fm / 16.07.2003
Synchronising the TCP/IP settings with the Gigaset SE505 dsl/cable
You have now configured your PC so that it is ready to be connected to the Gigaset
SE505 dsl/cable. You now have to release the old TCP/IP settings and match them to the
settings of your Gigaset SE505 dsl/cable.
◆
Click on Start – Run.
◆
Type WINIPCFG and click on OK.
There may be a slight delay before the IP Configuration appears.
◆
Select your network adapter from the selection list.
◆
Click on Release and then Update.
If the router's default IP address (192.168.2.1) was not changed, the IP address
should now read 192.168.1.x (x being a number between 2 and 254). The Subnet
Mask must always be 255.255.255.0 and the Default Gateway must have the
router's IP address (192.168.2.1). These values confirm that your Gigaset SE505 dsl/
cable is working.
◆
Click on OK to close the IP Configuration window.