Sierra INNOVA-MASS 241-VTP - Manual (Page 32)

Chapter 2 Installation Series 24-HP Instruction Manual
2-18 IM-24-HP
Enclosure Adjustment (Series 240 Only)
Figure 2-13. Enclosure Viewing Adjustment
To avoid damage to the sensor wires, do not rotate the enclosure beyond
180-degrees from the original position. To adjust the enclosure:
1. Remove power to the flow meter.
2. Loosen the three set screws shown above. Rotate the display to the
desired position (maximum 180-degrees).
3. Tighten the three set screws. Restore power to the meter.