KORG TRINITY HDR-TRI - Manual (Page 11)

Settings for recording
8
Checking the external input
Before you begin, go to “Song settings” ( ☞ page 7 of this manual) and select an
audio track (AT1 for this example).
1 Access the Sequencer mode P1 tab 5 page (ATrkRec).
2 Select the Input Select item.
If you are recording from an analog device such as a guitar connected to the
ANALOG IN 1 or 2 jack, select
Analog .
Input from the ANALOG IN 1 jack will be recorded on audio track 1 or 3.
Input from the ANALOG IN 2 jack will be recorded on audio track 2 or 4.
If you are recording from a digital device such as a DAT connected to the S/P
DIF connector, select
Digital . In this case, make sure that the Global mode P2
System Clock setting is set to S/P DIF . If you are recording from a digital device,
proceed to step 6 .
If a digital signal containing a copy inhibit flag is input, the display will indicate
Copy Inhibit . The HDR-TRI is able to record a digital signal which contains the
SCMS (Serial Copy Management System) flag. However it will be recorded as
digital audio data without the SCMS flag.
When digitally recording from copyrighted audio material such as a com-
mercial DAT tape, you must be sure to obtain permission. Otherwise, you
must use non-copyrighted material. Korg will take no responsibility for
the consequences of any copyright violation which you may commit.
Input from the S/P DIF connector will be recorded with the left channel of the
source on audio track 1 or 3, and the right channel on audio track 2 or 4.
It is not possible to record a sampler or CD with a sampling frequency
other than 48 kHz via the S/P DIF connector. If you wish to record from
such a sampler or CD, use the ANALOG 1 or 2 jacks.
1 6 4
2
3