KORG TRINITY HDR-TRI - Manual (Page 30)

Sequencer P1
27
Introduction
Operation
Parameters
Appendix
1–6i: Volume [0...100...127]
Adjusts the volume of each audio track.
A setting of
0 is – ∞ , 100 is 0 dB, and 127 is +12 dB.
Depending on the selection in “1–6j: Mix Audio Track Mode,” it may not be pos-
sible to modify this parameter. Refer also to “1–6j: Mix Audio Track Mode.”
1–6j: Mix Audio Track Mode [MANUAL/READ/MUTE/SOLO/WRITE]
When a track is played back with a setting of MANUAL , the mixer events that
were recorded will be ignored, and EQ, Send, Pan, and Volume will be set man-
ually.
When a track is played back with a setting of READ , the mixer events that were
recorded will be played back. Even if you adjust EQ, Send, Pan, or Volume dur-
ing playback, the setting will change to the setting of a mixer event when the
location of that mixer event is reached. (If there are no mixer events, the param-
eters can be set in the same way as for MANUAL.)
When a track is played back with a setting of MUTE , the muted audio track will
not be heard.
When a track is played back with a setting of SOLO , all other audio tracks will
be set to MUTE, and you will hear only the sound of the selected audio track.
Audio tracks which are set to SOLO will be played back according to the mixer
events which were recorded. At this time, even if you adjust EQ, Send, Pan, or
Volume during playback, the setting will change to the setting of a mixer event
when the location of that mixer event is reached.
Two or more audio tracks can be set to SOLO, but the modes which can subse-
quently be selected for each audio track will differ as follows, depending on
whether only one, or two or more audio tracks were set to SOLO.
When SOLO is selected for one audio track
If the SOLOED audio track is switched to a different mode, audio tracks which
are MUTED will switch to the same mode as was selected for the previously
SOLOED audio track.
For example if the SOLOED audio track is switched to MANUAL, the MUTED
tracks will also be switched to MANUAL. Similarly, if the SOLOED audio track
is switched to WRITE, the MUTED tracks will also be switched to WRITE.
So be careful not to accidentally record over existing tracks.
When SOLO is selected for two or more audio tracks
Select WRITE to record mixer events. In order to record mixer events, select
Mixer Rec as the Track setting, and select WRITE here. Then begin recording
(simultaneously press the [REC] key and the [PLAY] key). The various audio
track parameters that were set in this tab page will be recorded as
mixer events
in the range of measures specified by Recording Setup in “1–7: Preference.” Dur-
Selectable modes
SOLO tracks MANUAL, READ, MUTE, SOLO, WRITE
MUTE tracks SOLO, MUTE
Selectable modes
SOLO tracks SOLO, MUTE
MUTE tracks SOLO, MUTE