KORG TRINITY HDR-TRI - Manual (Page 16)

Playback
13
Introduction
Operation
Parameters
Appendix
Recording mixer events
You can record pan, volume and equalizer settings as mixer events on the audio
track. The audio track will be played back according to the Pan/Volume, EQ,
and Send 1/2 settings that were recorded.
1 Use the procedure “Recording an audio track” to record an audio track.
2 Access the Sequencer mode P1 tab 7 page (Preference).
3 In Recording Setup, specify the recording method for mixer events.
When recording mixer events, select Overwrite.
Alternatively, you may use Auto Punch-In or Manual Punch-In to specify the
measures of the area in which recording will take place.
4 Access the tab 6 page (MixA1–4).
5 For the Track selection, select MIXER REC.
6 For the audio track on which you want to record mixer events, set the Mix Audio
Track Mode to WRITE.
For audio tracks on which you do not want to record mixer events, set the
Mix Audio Track Mode to READ or MANUAL.
7 Press the [RESET] key to return to the beginning of the songpress the [REC/WRITE]
key and then (after making sure that the [START/STOP] key, LED is blinking) press
the [START/STOP] key.
Recording will start.
8 While listening to the song, adjust EQ, Send 1/2, and Pan/Volume for the audio
track on which you want to record mixer events.
If you execute the page menu command “Volume Pairing,” adjusting the vol-
ume of one channel in a stereo pair will simultaneously adjust the volume of the
other channel.
9 When you are finished, press the [START/STOP] key.
4
5
8
6