KORG TRINITY HDR-TRI - Manual (Page 48)

Sequencer P5
45
Introduction
Operation
Parameters
Appendix
For details on the procedure, refer to “5–3E: Erase Measure.”
5–4F: Delete Measure
This command deletes specified measures of playback data from the track
selected in the tab 3 page.
Unlike the Erase Measure command, executing the Delete Measure command
will cause playback data following the deleted area to be moved forward
toward the beginning of the song.
For details on the procedure, refer to “5–3F: Delete Measure.”
5–4G: Insert Measure
This command inserts the number of measures specified in the dialog box into
the track specified in the tab 3 page. When the Insert Measure command is exe-
cuted, the measures will be inserted at the location specified by the Start Mea-
sure. The playback data following the inserted location will be moved backward
toward the end of the song.
For details on the procedure, refer to “5–3G: Insert Measure.”
5–4H: Copy Measure
This command copies specified measures of playback data from the audio track
selected in the dialog box to the Start Measure of the audio track selected in the
tab 3 page.
Be aware that the playback data will change as follows when the Copy Measure
command is executed.
• If measures which contain no playback data are copied, the copy destination
measures will be blank.
• Any playback data existing at the copy destination will be erased, and
replaced by the copied playback data.
• The playback data that is copied will be played back according to the time
signature of the copy destination.
For details on the procedure, refer to “5–3H: Copy Measure.”
5–4I: Move Measure
This command moves playback data of the audio track selected in the dialog
box to the Start Measure location of the audio track specified in the tab 3 page, in
steps of a measure.
Be aware that the playback data will change as follows when the Move Measure
command is executed.
• Playback data located after the move source measures will be shifted forward
by the number of measures that were moved.
• Playback data located after the move destination measure will be shifted
backward by the number of measures that were moved.
For details on the procedure, refer to “5–3I: Move Measure.”
5–4J: Audio Event Edit
This command lets you perform event editing of audio events (events in an
audio track), and trim the sound that is used by an audio event (make sample-
unit adjustments in the location or portion of a sound that will be played back).
You can use the Trim dialog box to modify the sound name after recording.
For details on the procedure, refer to “5–3J: Audio Event.”