KORG TRINITY HDR-TRI - Manual (Page 25)

Sequencer P1
22
1–5d: Track [T01...16, MTR, AT1(L), AT2(R), AT3(L), AT4(R),
AT1&2, AT3&4, MIXER REC]
Select the track that you wish to record.
When the
HDR-TRI is installed, you will be able to select audio tracks AT1(L) ,
AT2(R) , AT3(L) , AT4(R) , AT1&2 or AT3&4 , and MIXER REC in addition to the
MIDI tracks T01–16 and the MTR (Master Track) that were previously available.
When T01–16 are selected, you can record onto the selected MIDI track. Basic
settings for recording a MIDI track and settings that determine how the notes
will be sounded and output are made in “1–1: Track Play/Rec”–“1–4: Mixer
(Track 9–16),” and the recording method is selected in “1–7: Preference.”
When a MIDI track is selected, playing the keyboard and operating the control-
lers will cause the internal tone generator to sound with the settings (program
and level, etc.) of the MIDI track that you select here (if the Track Status is INT
or BOTH). In addition, other MIDI tracks with the same MIDI channel will also
sound (if the Track Status is INT or BOTH). Furthermore, messages will be
transmitted on the MIDI channels specified for those MIDI tracks (if the Track
Status is EXT or BOTH).
If you play the keyboard while an audio track is selected in “1–5: Track,” the set-
tings (MIDI channel, Program, Track Status etc.) of the last-selected MIDI track
will be used.
When realtime recording a single track, the musical data will be recorded onto
the MIDI track you select here.
When realtime recording multiple tracks, you can specify in “1–1i: PLAY/
MUTE/REC” whether recording will occur for each MIDI track.
Select MTR when using “5–1: Track Edit” to edit the master track.
If AT1–AT3&4 is selected, you can record onto the selected audio track(s). When
AT1&2 or AT3&4 are selected, you can record a stereo pair of audio tracks. The
audio track(s) selected here will also appear in the “1–5l: Rec Audio Track Name
Display.”
Here you can make basic settings for recording the audio track(s), set the output
level and EQ settings, etc. in “1–6: Mix Audio Track 1–4,” and select the record-
ing method in “1–7: Preference.”
Select
MIXER REC when you wish to record mixer events using “1–6: Mix
Audio Track 1–4.”
The audio track name displayed here is set in “5–4: Audio Track Name,” and the
MIDI track name is set in “5–2: Track Name.” However if AT1&2 or AT3&4 are
selected, the audio track name will not be displayed.
This parameter is displayed in all pages “1–1: Track Play/Rec” through “1–7:
Preference,” and can be modified from any page.
1–5e: Meter/Metronome/Resolution/Multi Rec/Remove Data
Multi Rec
If this is checked , multi-track recording mode will be used, but the audio tracks
cannot be recorded.
If this is
un-checked , single-track recording mode will be used. Un-check this
when you wish to record audio tracks.