KORG TRINITY HDR-TRI - Manual (Page 18)

Editing
15
Introduction
Operation
Parameters
Appendix
portion of track has not been lost.)
9 When you are finished, press the [START/STOP] key.
Editing
Creating repetitions of the same phrase
1 Record using the procedure “Recording an audio track.”
2 Access the Sequencer mode P5 tab 3 page (Atrk Edit).
3 In the Track setting, select the audio track that you wish to edit.
4 In the Start Measure field, specify the copy destination.
5 Press the page menu command “Copy Measure.”
6 In the dialog box, make settings for Song, A.Track, and Measure Start/End to
specify the phrase that you wish to re-use, and then press the OK button.
The phrase of the area you specified here will be copied to the measure of the
track that you specified in step
4 .
7 Repeat steps 4 – 6 .
8 Press the [RESET] key to return the current location to the beginning of the song,
and then press the [START/STOP] key to listen to the playback.
Track bouncing (“ping-pong” recording)
Here’s how to bounce (i.e., combine or “ping-pong”) audio tracks 1, 2 and 3 to
audio track 4. Because the TRINITY can bounce tracks in the digital domain,
you can perform this operation any number of times without degrading signal
quality.
1 In the Sequencer mode, set Track to AT4(R).
2 In the Sequencer mode P1 tab 6 page (MixA1–4), set audio track 4 to a Volume of
0.
To be sure that audio track 4’s volume stays at 0, set its Mix Audio Track Mode
to Manual.
3 In the Sequencer mode P1 tab 1 and 2 pages (Trk1–8, Trk9–16), set each MIDI
track’s Track PLAY/MUTE/REC setting to MUTE.
2
5
3
4