Relay smtp server, 3 relay smtp server – Kerio Tech Firewall6 User Manual
Page 238
Chapter 18
Other settings
238
18.3 Relay SMTP server
WinRoute provides a function which enables notification to users or/and administrators by
email alerts. These alert messages can be sent upon various events, for example when a virus
is detected (see chapter
), when a Peer-to-Peer network is detected (refer to chapter
when an alert function is set for certain events (details in chapter
) or upon reception of
an alert (see chapter
For this purpose, WinRoute needs an SMTP Relay Server. This server is used for forwarding of
infected messages to a specified address.
Note: WinRoute does not provided any built-in SMTP server.
To configure an SMTP server, go to the SMTP server tab in Configuration → Advanced Options.
Figure 18.5
SMTP settings — reports sending
Server
Name or IP address of the server.
Note: If available, we recommend you to use an SMTP server within the local network
(messages sent by WinRoute are often addressed to local users).
SMTP requires authentication
Enable this option to require authentication through username and password at the spec-
ified SMTP server.
Specify sender email address in “From” header
In this option you can specify a sender’s email address (i.e. the value for the From header)
for email sent from WinRoute (email or SMS alerts sent to users). Preset From header does
not apply to messages forwarded during antivirus check (refer to chapter
).
This item must be preset especially if the SMTP server strictly checks the header (mes-
sages without or with an invalid From header are considered as spams). The item can also